Hypercom ICE 4000, Руководство по аппаратному обеспечению и установке, Страница: 3 / 25

n This device must not be installed on coin-operated telephone lines or party lines.
n This device (equipment) complies with the requirements in Part 15 of FCC Rules for a Class A
computing device. Operation of this device (equipment) is subject to the following two conditions:
– This device (equipment) may not cause harmful interference, and
– This device must accept any interference received, including interference that may cause
undesired operation.
n If this device (equipment) is used in a residential area, it may cause unacceptable interference to
radio and TV reception requiring the operator to take whatever steps necessary to correct the
interference.
n Repair work on this device (equipment) must by done by Hypercom Corporation or an authorized
repair station.
This equipment has been tested and found to comply with the limits for a class B digital devise, pursuant
to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses, and can radiate radio frequency
energy and if not installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio and or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to attempt to correct the
interference by one or more of the following measures:
n Reorient or relocate the receiving antenna
n Increase the separation between the equipment and the receiver
n Connect the equipment into an electrical outlet on a circuit different from that to which the receiver
is connected
n Consult the dealer or an experience radio or television technician for assistance
This equipment has been certified to comply within the limits for a Class B computing devise, pursuant to
FCC Rules. In order to maintain compliance with FCC regulations, shielded cables must be used with this
equipment. Operation with non-approved equipment or unsheilded cable is likely to result in radio and or
television interference. The user is cautioned that changes and modifications made to this equipment
without the expressed approval of the manufacturer, could void the user’s authority to operate this
equipment.
WARNING:
To comply with FCC RF exposure requirements, the CDPD or Mobitex units must be operated with a
minimum separation distance of 3 cm (1-1/8 inches) between its antenna and a person’s body. The user’s
hand should not be placed next to the antenna or at locations on the unit where the antenna is connected.
A minimum separation distance of 1.5 cm is needed to ensure compliance with FCC RF exposure limits
for the hand.
FCC PART 15 REQUIREMENTS NOTICE