Hypercom ICE 4000, Руководство по аппаратному обеспечению и установке, Страница: 18 / 25

Equipment Installation
940265-001 Hypercom Corporation 2-3
Turning On the Terminal
The ICE 4000 terminal operates using a +12 Vdc power cable in conjunction with a 110-Volt
grounded power receptacle.
Step-by-Step
To turn on the ICE 4000 terminal:
1. Connect the +12 VDC power cable from the AC adaptor to the terminal power socket labeled
PWR .
2. Plug the adaptor into a 110-Volt grounded power receptacle. Press the power switch. Be
sure the connector is firmly seated. When the power is connected successfully, the terminal
beeps twice and then performs a self-test and diagnostic routine.
N
OTE
:
To fully charge the battery for mobile use, plug in the +12 VDC power cable and turn the
terminal on. Leave the terminal powered up for 4 to 6 hours before using.
W
ARNING
Do not use an adaptor, a power extender adaptor, a power extender cable, or an AC outlet that
does not have a ground connection.
Do not disassemble the AC adaptor. Only qualified service personnel should service the adaptor.
The AC adaptor was designed for indoor use only. Do not expose to rain or snow.
Do not immerse in fluid.
The reliability of electronic equipment is significantly reduced when it is powered from an
underground outlet. A low-power AC adaptor connects power to the terminal. Connect only one
terminal to the AC adaptor.