Hyper Tough HT19-401-003-18, Руководство оператора

Страница: 8 / 24

8
ACTION FIGURE
Assembly
Assembling the Shaft See Fig. A
Assembling the Auxiliary Handle See Fig. B
Attaching the Extension Cord
See Fig. C1&C2
Operation
Setting to the edging position See Fig. D1
Edging
See Fig. D2&D3
Adjusting Cut Depth
See Fig. E1&E2
Setting to the trenching/landscaping position
See Fig. F
Trenching and landscaping operation
Removing and attaching the blade
See Fig. G1&G2
OPERATION INSTRUCTION
NOTE:
The edger is a major appliance and should not be operated simultaneously with other major appliances on the same
household circuit.
Warning: Make sure that other persons and pets are at least 100 feet away.
EDGING
1. Before starting the edger, line up the tool so the edge guide rests against the edge of the paved surface. Both rear wheels
should be on the paved surface when edging. (See Fig D2)
2. To avoid kickback of edger, tilt the handle down so the blade is above the ground (See Fig D3).
3. Turn switch ON and allow blade to spin without moving tool.
4. Slowly lift the handle to lower the blade, finding the edge of the paved surface and start edging. Then move tool
forward slowly along edge of paved surface, keeping the edge guide pressed lightly against the pavement edge. For
the first edging each season, it is best to move forward slowly because grass is thickest then. Subsequent edging will
TECHNICAL DATA
Rated Voltage 120V~60Hz
Rated Power 12A
Rated No-load speed 4700/min
Protection class
/ll
Blade diameter 7-1/2"
Blade cutting depth 1", 1-1/4", 1-1/2"
Machine weight 14.2lbs
We recommend that you purchase your accessories from the same store that sold you the tool.
Refer to the accessory packaging for further details. Store personnel can assist you and offer
advice.
ASSEMBLY & OPERATION