Hyper Tough HT19-401-003-03, Руководство оператора

Страница: 9 / 36

9
ASSEMBLY AND OPERATION
ACTION FIGURE
Assembly
Assembling the Main Handle
See Fig. A
Assembling the Auxiliary Handle See Fig. B1, B2
Assembling the Safety Guard
See Fig. C
Assembling the Flower Guard
See Fig. D
Removing the Blade Protect Label
See Fig. E
Installing and Removing the Battery Pack
NOTE:
• This machine will only run when 2 batteries are installed. It is recommended
to use the same two batteries and charge the two batteries at the same time.
• When you use two batteries with different power, the machine will only run to
the lower common denominator.
See Fig. F1, F2
Charging the battery pack
NOTE:
• The batteries are shipped uncharged. Each battery must be fully charged before the
first use.
• Always fully charge the two batteries at same time. More details can be found in
charger’s manual.
See Fig. F3
OPERATION
On/Off Switch
WARNING!
The cutting head continues to rotate after the trimmer has been switched
off; wait until it has completely stopped then lay down the tool.
See Fig. E
Trimming
See Fig. H
Adjusting the Trimmer Head/Auxiliary Handle
See Fig. I1, I2, J3
Edging
See Fig. J1 - J4
Command feeding the line
See Fig. K
Manually feeding the line
See Fig. L
Replacing the trimmer line and spool
See Fig. M, N, O
Manually winding the line
See Fig. P, Q, R, S
FOR CHARGER HT19-401-003-14
IMPORTANT NOTES FOR CHARGING BATTERY
The battery in your new tool is not charged when it leaves the plant. Therefore it must be full charged before using the first
time.
NOTE:
If the battery pack is very hot you must remove your battery pack from the charger and allow your battery pack to cool
first to ambient temperature and then recharging can be started.
To prevent damage to the Battery Pack, when charge runs out, please charge the battery to reach full or no less than half
charge before storage.
If the tool will not be used for long periods of time, charge the battery every 3-6 months.
OPERATION INSTRUCTIONS