Hyper Split Hydraulic Log Splitter
ToolTuff Direct LLC, 15000 W44th Ave, Ste B, Golden CO 80403 Page 9
hydraulic reservoir. Please check the tank window to fill properly. Fill about 20
ounces of engine oil. See engine manual for oil caution.
Caution
: When tightening the breather cap on the tank, point the hole away from
the engine
Step 2
: Start the engine. The hydraulic pump should prime itself. With
the engine running, move the hydraulic valve lever toward the wedge.
When the cylinder is fully extended, retract it. Replace this operation for
a few times before splitting.
Caution
: If the tank is overfilled, it will expel oil from the breather cap. If
the tank needs more hydraulic oil, you will see foam through the
hydraulic hose connected between tank and log splitter pump. Due to
the special cylinder for hyper split, the engine may have some loud
noise when the cylinder is retracting. This is normal situation. You can
continue using this log splitter without any issue.
STARTING INSTRUCTIONS
•
Make sure the log splitter valve is at neutral position.
•
Move control lever to “OK”
•
Move chock lever to choice position.
•
Grasp starter rope handle and pull out slowly until resistance is
felt. Then pull rapidly with a full stroke. Repeat the last step if
engine fails to start.
•
When engine starts, leave control lever at “FAST”. The throttle
must be in the “FAST” position for maximum performance.
•
To stop engine, move the throttle lever to “Slow” and then to
“STOP”.
Step 3
: For horizontal operation, please a log on the beam against the
footplate. Make sure the log sits securely on the footplate. To split wood
in the vertical position, release the beam lock pin on the beam located
near the front end of the beam. Carefully tilt the beam up until the
footplate is sitting squarely on the ground and the log splitter is stable.
When the beam is returned to the horizontal position makes sure the
beam is securely locked down.
