HYOSUNG GT125 - PARTS CATALOGUE, Руководство пользователя

Страница: 57 / 106

56
5. Park the motorcycle on a firm, flat
surface where it will not fall over.
Following another vehicle too closely
can lead to a collision. As vehicle
speeds increase, stopping distance
increases progressively.
Be sure you have a safe stopping
distance between you and the vehicle in
front of you.
WARNING
A hot muffler can burn you. The muffler
will be hot enough to burn you for some
time after stopping the engine.
Park the motorcycle where pedestrians
or children are not likely to touch the
muffler.
WARNING
6. Turn the ignition key to the “OFF”
position.
7. Push down the ignition key from the
“OFF” position, come up again and turn it
to the “LOCK” position.
8. Remove the ignition key.
The opening explains how important
proper break-in is to achieve maximum life
and performance from your new
Hyosung .
The following guidelines explain proper
break-in procedures.
Less than 3/4 throttle
Less than 1/2 throttle
Up to 1,600 km (1,000 miles)
Initial 800 km (500 miles)
★ ★
MAXIMUM THROTTLE OPENING
RECOMMENDATIONS
The table below shows the maximum
throttle opening recommendation during the
break-in period.
★ ★
AVOID CONSTANT LOW SPEED
Operating the engine at constant low
speed(light load) can cause parts to glaze
and not seat in. Allow the engine to
accelerate freely through the gears, without
exceeding the recommended maximum
limits. Do not, however, use full throttle for
the first 1,600 km (1,000 miles).
★ ★
VARY THE ENGINE SPEED
The engine speed should be varied and
not held at a constant speed.
This allows the parts to be “loaded” with
pressure and then unloaded, allowing the
parts to cool.
This aids the mating process of the parts.
It is essential that some stress be placed on
the engine components during break-in to
ensure this mating process.
Do not, though, apply excessive load on
the engine.
BREAK-IN