HYOSUNG GT125 - PARTS CATALOGUE, Руководство пользователя

Страница: 50 / 106

49
Approximately 1,450
㎖ ㎖
of engine oil
must be required when changing engine
oil only without replacing the oil filter.
CAUTION
7. Before replacing the engine oil filter cap
⑥
, be sure to check that the engine oil
filter spring
④
and the “O” ring
⑤
are
installed correctly. Use new “O” ring
each time the engine oil filter element is
replaced.
8. Replace the oil filter cap
⑥
and tighten
the nuts securely but do not over tighten
them.
9. Replace the drain plug and tighten it
securely. At this time, insert the gasket
necessarily.
10. Pour fresh engine oil through the
engine oil filler hole. Approximately
1,500
㎖
of the engine oil will be
required.
11. Install the engine oil filler plug.
In case of the engine oil pouring
excessively, the engine output being
made insufficient.
Be careful not to pour engine oil.
CAUTION
Failure to use the correct oil can damage
your motorcycle.
Engine damage may occur if you use the
engine oil that does not meet Hyosung’s
specifications.
Be sure to use the engine oil specified in
the FUEL AND OIL RECOMMENDATION
section.
CAUTION
12. Start the engine and allow it idle for a
few minutes. Check to see that no the
engine oil is leaking from the oil filter
cap and drain plug.
13. Check the oil level according to Engine
Oil Level Check procedure.
Engine oil leaks from around the oil filter
cap or drain plug indicate incorrect
installation or the “O” ring / gasket
damage. If you find any leaks or are not
sure that the oil filter cap / drain plug has
been properly installed, have the
motorcycle inspected by your Hyosung
dealer or qualified mechanic.
CAUTION