2
From Left to right:
- Charge Level: indicators for
the battery charge level.
- Charging: indicates when the
Job Light is charging.
- Battery OK: battery check LED.
- USB (500ma/1000ma)
- DC Jack + inner.
HOW TO OPERATE THE JOB LIGHT:
Fully charge before use.
Slide and lock the battery to the unit.
Charge by mains, car or laptop via the USB charge point.
Check the charging levels via the charge level indicator.
Once charged you can operate the Job Light.
The Mightylite can be powered from either USB port or the power jack connected to a 5V 500ma or 1000ma power
supply. On the unit there are five LEDs. Three red LEDs together, these indicate the battery charge level.
Next to the charge level LEDs there is a charging LED indicator, when charging this will flash red, when the battery is
fully charged it will turn green. If this LED is flashing orange it indicated the battery is not connected correctly and the
unit will not function. The LED marked battery ok indicates that the unit is connected to an external power source and
the systems are functioning.
To operate, unplug from external power source and switch on. Note; that the LEDs indicators will briefly flash through
an initialisation set up, the lamp will now illuminate. The power of the lamp can be adjusted by switching the power
switch on and off within 2 seconds this will reduce the lamp by 50% and increase the battery life. Repeat again and it
will reduce to 25% and again double the battery life.
When the fitting is plugged into the charger the floodlight cannot be used.
Within10 seconds of charging the Mightylite will go out and will now operate in emergency mode, if the power is then
removed from either the DC jack or the USB input then the light will illuminate after10 seconds.
BATTERY CONDITION LED
BATTERY LIFE (APPROXIMATE):
Charge time = Full charge 6hrs
8W Tool Light
Description
16W Tool Light
28W Tool Light
8Hrs
24Hrs 36Hrs
12Hrs
2AH
4AH
6AH 12AH 18AH
4Hrs
4Hrs
2Hrs
12Hrs 18Hrs
6Hrs
2Hrs
6Hrs
9Hrs
3Hrs
1Hr
16Hrs
48Hrs 72Hrs
24Hrs
2AH
4AH
6AH 12AH 18AH
8Hrs
8Hrs
4Hrs
24Hrs 36Hrs
12Hrs
4Hrs
12Hrs 18Hrs
6Hrs
2 Hrs
High Power 100%
Medium Power 50%
Low Power 25%
4Hrs
12Hrs 18Hrs
6Hrs
2AH
4AH
6AH 12AH 18AH
2Hrs
2Hrs
1Hrs
6Hrs
9Hrs
3Hrs
1Hrs
3Hrs 4.5Hrs
1.5Hrs
30 Min
IMPORTANT
The unit will not operate correctly unless it is fully charged.
• Check the contents in the box
• Build the H Stand as shown on the next page using the clips provided and make sure the handle is secure.
• Mount the H Stand Job Light using the KNURLED BOLTS provided.
• Slide on the battery to the back of the Job Light until it’s clipped securely into place.
• Charge the battery before you use the Job Light.
• Once fully charged the Job Light can be used.
Disconnect the battery and place somewhere safe when not in use.
