hydrotab 3DHC, Руководство по эксплуатации

Страница: 15 / 28

Hydro
Tab
Marine Engineering
15
Hydro
Tab
Marine Engineering
The 3DHC Controller
The 3DHC controller operation
Interceptors operate when voltage comes from the ignition.
When there is no voltage from the ignition, system does not
work.
System Reset - Retracting
The system resets and interceptors retract automatically:
Ÿ
On Engine start
Ÿ On Engine stop
Ÿ
On simultaneously pressing the UP + DOWN buttons for
1 second.
Note: During reset process controller LEDs are flashing.
Night and day mode
T h e i n d i c a t i o n b r i g h t n e s s c h a n g e s b y p r e s s i n g
simultaneously the buttons LEFT + RIGHT for 1 second.
Memory
Setting the desired trim angle
You may save the desired trim angle for the cruising speed.
Just manually adjust the position and then press
simultaneously any diagonal press buttons for about 3
seconds. This position of trim tabs is stored in 3DHC
memory and the power-on led is flashing to confirm the
setting.
Whenever the user presses instantaneously two diagonal
press buttons, the trim tabs get the preset position.
The saved position is stored even after switching off the
main switch of the boat.
Maintenance
Check connectors for corrosion or liquid pollution.
Check in regular intervals the condition of the sacrifice
anodes. Below 50% in volume, anodes must be replaced.
When the boat is out of the water (end of season):
a. extend the blades
b. spread the decalcifying liquid with a brush
c. let it for 15-20 min
d. wash out with clean water
e. retract the blades
Every two years remove the cover and clean the inside of
the units, using water pressure.
Every three years check the springs condition.
Bow
Down
Up
Bow Down
Bow Up
Right
Left
Malfunction indication
BLINKING LED MALF UNCTION
1st green on the left Left Interceptor does not return
1st green on the right Right Interceptor does not return
2nd green on the left Left Interceptor does not extend
2nd green on the right Right Interceptor does not extend