hydrotab 300SR, Руководство по эксплуатации

Страница: 7 / 20

7
Hydro
Tab
Marine Engineering
Interceptor Installation
6
You will need
No 4 No 8,5
No 5,5
Lower edge of the trim unit
Κάτω μέρος του φλαπ
Lower edge of the hull
Άκρη γάστρας
Use drill Ø 5,5 mm x 10holes
Χρησιμοποιήστε τρυπάνι Ø 5,5 mm x 10 τρύπες
SR450
Use drill Ø 8 .5mm
Χρησιμοποιήστε τρυπάνι Ø8 . 5mm
Use drill Ø4mm
Χρησιμοποιήστε τρυπάνι Ø4mm
Use drill Ø4mm
Χρησιμοποιήστε τρυπάνι Ø4mm
Remove the pattern and drill according to the
pattern indications.
5
Tape
Drill all the pattern holes with a 3mm bore without
removing the pattern.
You will need
No 3
7
Apply sealant Sikaflex 291 to the holes.
You will need
Sikaflex Gun
8
Use a spatula to clean the excessive glue from the
holes.
You will need
Spatula
9
For Direct Air Supply: Advise the instructions.
For Indirect Air Supply: Use the components included in the kit.
Direct air supply
Optional:
Indirect Air Supply Kit