HYDROSCAND MaxiCut 5-60, Руководство пользователя, Страница: 10 / 28

MaxiCut 5-60 USER MANUAL EDITION 2-05 2012-10-23
10
7. Hose cutting
7.1 Running in the cutting blade
New cutting blades must be used with reduced speed for the feeding at about
100-200 cut. When the running-in has been done the cut can be performed at
normal speed. As a basic rule the blade should never be overheated. If excessive
smoke or heat is generated or if the motor stalls the cut sequence must be inter
-
rupted immediately and the cause found.
7.2 Different hose dimensions
Important !
When cutting...
... hoses of dimension 3/16”- 1/2” must the cutting supports always be used and
put in the two inner holes. Min. cutting length 150 mm. Cutting speed no. 2 or 3
can be used for these dimensions.
... hoses of dimension 5/8”- 1”must the cutting supports always be used and put
in the two outer holes. Min. cutting length 250 mm. Cutting speed no. 1 or 2 can
be used for these dimensions.
... hoses of dimension 1 1/4”- 2”, layers shall the cutting supports NOT be used.
Min. cutting length 300 mm. The cutting speed has to be switch to no.1.
note !
Before cutting hoses of dim. 1 1/4” - 2” a cutting test has to be performed
without a hose as below:
1.
Switch the cutting speed to no.1 speed.
2.
Set the cutting stroke adjustment knob to zero.
3.
Press the pedal and visually check that pusher have a slow movement down -
wards. As factory default a complete stroke take about 9 seconds. The speed may
have to be reduced more if mostly tough hoses are cut.
If excessive smoke or heat is generated or if the motor stalls when cutting the
hose adjust the speed to optimize the cut. Contact Hydroscand Machine AB for
further information about adjusting the speed.