HydroQuip BALBOA CS6000B Series, Руководство по эксплуатации

Страница: 26 / 32

Power has been cut off to the
Temperature unknown.
“Overheat” - The spa has shut
the sensors has
“Overheat” - The spa has shut
the sensors has
110°F/43.5°C.
Spa is shut down.* The sensor
into the Sensor
Spa is shut down.* The sensor
into the Sensor
Sensors are out of balance. If
spa
condition. If f lashing by itself, spa
A signif cant difference between
temperature sensors has been
a f low problem.
Persistent low f ow problems.
f ifth occurrence
24 hrs.)
Functions continue to run
Possible inadequate water, poor
f low, or air bubbles in detected
in the heater. Spa is shut down
Inadequate water detected in
on third
message.)
shut down.*
Meaning
The control panel will be disabled until power
After the pump has been running for 2 minutes,
temperature will be displayed.
DO NOT ENTER THE WATER. Remove the spa
water to cool. Once the heater
If spa does not reset, shut off the power
your dealer or service
DO NOT ENTER THE WATER. Remove the spa
water to cool. At 107°F/41.7°C,
If spa does
dealer or service organization.
If the problem persists, contact your
(May appear
contact your dealer or
If the water level is normal, make sure all
If problem persists,
Follow action required for “HL” message.
Heating capability of the spa will not reset
If water level is normal, make sure all pumps
primed. Press any button to reset.
within 15 minutes.
service organization.
Follow action required for “dr” message.
reset. Press any
No Message on display.
heater.
Message
Action Required
Spa Side Messages
Test sensors, possible defective sensor refer to
spa.
returns.
the current water
down.* One of
detected 118°F/47.8°C at the
cover and allow
to the spa and call
organization.
cover and allow
the spa should automatically reset.
not reset, shut off the power to the spa and call
your
down.* One of
detected that the spa water is
page 28.
dealer or service organization.
temporarily in an overheat condition.)
that is plugged
“A” jack is not working.
that is plugged
“B” jack is not working.
If the problem persists, contact your
(May appear
Test sensors, possible defective sensor refer to
page 28.
dealer or service organization.
temporarily in an overheat condition.)
service organization. alternating with
it may just be a temporary
temperature,
is shut down.*
pumps have been primed.
contact your dealer or service organization.
detected. This could indicate
automatically; you may press any button to
reset.
(Displays on the
of “HL” message within
normally.
have been
This message will reset
If problem persists, contact your dealer or
for 15 minutes.
Spa will not automatically
button to reset manually.
heater. (Displays
occurrence of “dr”
Spa is
has cooled, reset by pushing any button.
Cycle power to spa. If problem persists,
Clean or replace filter.
Clean or replace filter. Open all jets and valves.
Clean or replace filter. Open all jets and valves.
Clean or replace filter.
25