Hydromatic SPD100H, Инструкция по установке и обслуживанию

Страница: 7 / 12

7
Note: Too much pressure will
damage the seal.
Then submerge the pump in
water and check for leaks. If a
leak occurs, isolate where it is
coming from and correct the
problem by replacing the
sealing part. If there are no
plugs (#6). Turn pump on side
and fill seal chamber to 1"
from top. Replace plug (#8)
and stand pump up.
14.Connect power cord wires
to terminals in panel, or
connect power source, and
check pump running. Motor
should run smoothly and be
free of vibration.
leaks, fill the motor and
seal housing with high grade
transformer oil, such as Sohio
Factopure SE40 or equivalent,
to at least one inch below top
of housing.
Do not fill the motor housing
completely — allow air space
for expansion. Replace oil