2
Thank you for purchasing your
Hydromatic
®
pump. To help
ensure years of trouble-free
operation,
please read the
following manual carefully.
WARNING:
Only qualified
personnel shall install or service
this pump.
Before Operation:
Read the following instructions
carefully. Reasonable care and
safe methods should be practiced.
Check local codes and
requirements before installation.
Attention:
This manual contains important
information for the safe use of
this product. Read this manual
completely before using this
product and refer to it often for
continued safe product use.
DO NOT THROW AWAY OR
LOSE THIS MANUAL. Keep it
in a safe place so that you may
refer to it often.
Unpacking Pump:
Remove pump from carton. When
unpacking unit,
check for
concealed damage. Claims for
damage must be made at the
receiving end through the delivery
carrier. Damage cannot be
processed from the factory.
WARNING: Before handling
these pumps and controls,
always disconnect the power
first. Do not smoke or use
sparkable electrical devices or
flames in a septic (gaseous) or
possible septic sump.
WARNING:
Read all the
instructions before starting any
operation on pump.
Always disconnect the pump and
controls from its power source
before handling or making any
adjustments.
WARNING: Risk of Electrical
Shock—This pump has not been
investigated for use in swimming
pool areas.
WARNING: Risk of Electrical
Shock—This pump is supplied
with a grounding conductor
and grounding-type attachment
plug. To reduce risk of electrical
shock, be certain that it is
connected only to a properly
grounded,
grounding-type
receptacle.
1. Connect only to a properly
grounded,
grounding type
receptacle or control panel.
2. Septic tank is to be vented
in accordance with local
plumbing codes.
3. Do not smoke or use sparkable
electrical devices or flame in
a septic (gaseous) or possible
septic sump.
4. A septic sump condition may
exist and if entry into sump
is necessary, then (1) provide
proper safety precautions per
OSHA requirements and (2)
do not enter sump until
these precautions are strictly
adhered to.
5. Do not install pump in location
classified as hazardous per
N.E.C., ANSI/NFPA 70 - 1999.
Failure to heed the above
cautions could result in
injury or death.
General
Information
1.
CAUTION
– To reduce risk of
electrical shock, pull plug
before servicing this pump.
2.
WARNING
– Risk of electrical
shock – this pump has not
been investigated for use in
swimming pool areas.
3.
WARNING
– See installation
and service manual for proper
installation.
4.
WARNING
– To reduce risk
of electrical shock, pump is
provided with grounding wire.
Be certain that it is connected
to ground.
5.
WARNING
– Hazardous
moving parts. To reduce the
risk of injury, disconnect power
before servicing pump.
6.
CAUTION
– To reduce the
risk of electric shock,
DO NOT
remove cord or strain relief.
DO NOT
connect conduit to
pump. Electrical installations
shall be in accordance with the
National Electrical Code and
all applicable local codes and
ordinances.
7. For use with maximum
140°F water.
8. Tank should be vented in
accordance with local plumbing
codes and should not be
installed in locations classified
as hazardous, in accordance
with the National Electrical
Code, ANSI/NFPA 70-1999.
9.
CAUTION
– Risk of electric
shock. Do not remove cord
and strain relief. Do not
connect conduit to pump.
10.
WARNING
– Severe injury
may result from accidental
contact with moving cutters.
Keep clothing, hands and feet
away from cutters any time
power is connected to the pump.
Pump Cautions
and Warnings
Содержание HPD200
Страница 11: ......
