Hydromatic FlexLine FLH03, Руководство пользователя

Страница: 25 / 56

Page 25
*)
the numbers refer to the exploded view in
the chapter with the same name.
Make connection as follows:
» Attach cap nut with inner seal ring to
inlet screw joint on the humidifier
housing and tighten.
Do not overtighten the cap nut!
Excessive tightening will destroy the fitting.
» Screw the other hose end cap nut
with its inner seal on a customer-
provided water tap (cap nut internal
thread is ¾“) .
» Strainer must be placed inside the
solenoid valve
6.3 Water discharge
Risk of scalding!
During blow down, up to 0.3 l/sec (08 gal./
sec) are being drained with a temperature of
about 95 °C (203°F).
Ensure that the drain hose is reliably fas-
tened and wastewater can drain freely and
pressureless.
Humidifier installation location and wastewa-
ter discharge must be on the same pressure
level. In case of a drain connection on posi-
tive pressure, pls. consult your expert dealer.
Guidelines for water discharge composi-
tion
• Use flexible water hose
• Do not buckle drain hose
• Discharge line and drain pipe material
must be temperature resistant up to
95°C(203°F)
How to proceed
» Run a 1 1/4 " drain hose of 250 to
1000 mm (10 to 40 inch) length into
a pressure-free outlet according to
DIN EN 1717. The hose must be
guided sideways of the humidifier to
prevent ascending vapor from con-
densating on the humidifier`s hous-
ing.
Valid for all steam humidifiers (KITS are not
included):
» Fit drain hose to connection stub on
humidifier housing bottom side.
» Slide pump drain hose onto one of
the grounding clips (s. fig. below).
» Slide overflow hose of the HyFlow
system separator (if present) onto
the other grounding clip.
Water supply
1 -10 bar
(14.5 - 145 psi)
(100 x 10
3
- 100 x 10
4
Pa)
3/4” connection
SV
NOTICE
Please note
WARNING
!
Please note