1
Preparing for the Installation
What’s in the Box?
In the box there are the following parts, please check that
everything is included. If anything is missing, please call us at
1-281-500-9800.
•
1 Hydrofuse system
•
20 feet injection tube
•
1 check valve for injection point
•
1 ¼” to ½” NPT adaptor
•
1 1” Flow 20’ Cable
•
1 key for door
•
1 Installation Manual
Back Flow Prevention
Please be sure to adhere to all Federal, State and local
regulations
when installing
or
using
Hydrofuse products. Back Flow valves may be subject to
specific regulations in your area.
Planning out the Installation
When planning out the installation, look at the irrigation system layout from the viewpoint of how it will be
easiest to connect the Hydrofuse system.
Firstly, select the best place to install the Flow Sensor / Injection Point in the irrigation Main Line should be
installed after the sprinkler system backflow device but before the mainline tee’s off to go different directions
and BEFORE the first irrigation valve.
Once this is done, you can then determine the best location for the Hydrofuse machine itself. The Flow Sensor
and Injection Point comes with 20 feet of cable / tubing so ideally mount the machine as close as possible to
the where you will connect to the irrigation main line. The machine needs to be mounted to a wall, and there
should be a 120-volt outlet nearby.
Note:
Because the Hydrofuse system uses a Flow Sensor it will work with any number of irrigation zones. It
will sense the actual water flow and precisely inject the correct amount of fertilizer to suit the quantity of
water flowing in each zone.
