8
6. Route the Electrical Cable
– cut the
zip tie holding the electrical cable
and push the plug down through the
grommet at the bottom of the
machine as shown:
7. Run the Injection Pipe and the Flow Sensor
to the Hydrofuse unit. It’s best to run them in a piece of ½”
diameter flexible or rigid conduit. This protects them from shovels, weed whackers, etc.
8. Run the Flow Sensor cable
- through the hole in the bottom of the electrical enclosure.
Next, run them both through the hole in the bottom of
Hydrofuse unit. From there connect the injection tube to
the right side of the pump. Push the tube firmly into the
pump fitting.
