2
hydrofarm.com
parsource.com
ASSEMBLING THE REFLECTOR
1. Upon opening the box, note any dented, deformed, or damaged parts. If any part of your unit is broken or
damaged, immediately notify your retailer or distributor.
2. Remove reflector from plastic bag and inspect for any damages. Handle reflector carefully to avoid deforming
the reflector, which can effect the output efficiency.
3. Remove hardware from plastic bag and ensure you have all parts as shown in PHOTO A.
NOTE:
Hardware bag may be inside cardboard end piece.
4. For "Remote" configuration use:
4a. Install the two eyebolts into the tapped holes on top of the reflector as shown in PHOTO B.
4b. Install lamp into reflector connectors as shown in lamp instructions.
4c. Connect your ballast to the reflector using CSXCORD (sold separately) in PHOTO C.
5. For "Attached" configuration use (applies to Phantom Commercial DE Ballast only):
5a. Install only one eyebolt into the tapped hole in the top of the reflector located opposite (furthest from) the
input lamp connector as shown in PHOTO D. Install a second eyebolt into the ballast hanging bracket as
shown below in PHOTO E.
5b. Attach the reflector assembly to the rear of the Phantom ballast by inserting the pin on the reflector
bracket into the circular slot in the ballast chassis as shown in PHOTO F and sliding the reflector assembly
downward until the two large tabs at the bottom enter the slots in the ballast’s end cap as shown in
PHOTO G and the sheet metal clip securely grips the ballast’s end cap as shown in PHOTO H.
5c. Attach the ballast bracket to the other end cap of the ballast by inserting the bracket's two folded tabs
into the corresponding slots on the end cap as shown in PHOTO I. Be sure that the bracket’s inset clip (just
beneath the eyebolt) snaps securely onto the top of the end cap. When attached securely to the ballast,
the ballast bracket should appear as it does in photo J.
5d. Plug reflector into ballast and as shown in photo K.
Photo A
Photo C
Photo B
Photo G
Photo F
Photo E
Photo D
Photo K
Photo J
Photo H
Photo I
