Hydrofarm ActiveAqua AACH100HP, Инструкция по эксплуатации

Страница: 12 / 16

INSTRUCTIONS
www.Hydrofarm.com 12
4. Install at least 12-16 inches (30-40 cm) away from walls in order to give the chiller adequate
ventilated space. (Fig. 4)
5. Do not cover or move the chiller while it is operating.
6. The circulation water flow of the chiller is indicated in the technology parameter table. This chiller
does not have a water pump, so it needs a pump with an available external filter. Using a pump
without an external filter may cause a water leak or other damage. (Fig. 6)
7. Do not put the chiller on its side or upside down as this will cause damage to the chiller. If the
chiller is placed on its side, readjust the unit to its correct upright position and wait 20 minutes
before turning it on. (Fig. 7)
ASSEMBLY INSTRUCTIONS
1. Remove the chiller unit and all of the contained hardware from the box and packaging material.
2. Set the chiller unit upright in the desired area on a stable surface ensuring there is at least 1
' of
clearance around the body (sides, top and back) of the unit.
3. Install the inlet/outlet fittings onto the inflow and outflow threaded sites
NOTE: If the inflow and outflow fittings are different sizes, typically the larger one is used on the
inflow and the smaller one on the outflow.
4. Attach the desired length of tubing onto each inflow and outflow fitting adapter with the worm
drive hose clamps. The inflow should connect the chiller to the appropriate sized submersible
water pump, such as an Active Aqua Water Pump, in the proper sized reservoir (see attached
performance curve chart). The outflow tube should hang freely in the reservoir to re-introduce
the chilled water back into the holding tank.