HydroBikes EXPLORER I, Инструкция по сборке, эксплуатации и безопасности

Страница: 8 / 24

8 | www.HydroBikes.com
ASSEMBLE YOUR HYDROBIKE
®
STEP 1:
Attach the rudder
Lay the bike frame on its side (A) .
Locate the Rudder Assembly. Remove the collar on rudder pipe by
loosening the bolt with the provided allen wrench
(B) .
Then, insert the rudder assembly into the front tube of the bike frame by
depressing the two spring-loaded buttons and sliding the rudder shaft up
until the two spring loaded buttons extends beyond the top of the bike tube
(C) . Next, fit the rudder collar over the top of the rudder shaft and tighten
until snug (B). Do not tighten completely as it may need adjustment.
STEP 2:
Connect the floats with the cross tubes
Each float has two pre-installed bolts. Locate the black square plug on the
floats
(A) . This signifies the back of each float. Layout the two cross tubes
and four black knobs between the floats for easy access during this step.
Stabilize the float by standing over it and securing it upright with your legs. Fit
the first cross tube onto the front bolt on one of the float. Secure it to the bolt
by threading a black knob
(B) . Do not tighten fully. Holding the cross tube,
step over the second float and secure with your legs again for the bolt to be
upright. Insert the cross tubes on to the second float. Use a second black knob
to secure the cross tube.
Do not tighten fully. Repeat this step with the second
cross bar at the float rear bolts (C) .