HydroBikes EXPLORER I, Инструкция по сборке, эксплуатации и безопасности

Страница: 12 / 24

12 | www.HydroBikes.com
ASSEMBLE YOUR HYDROBIKE
®
STEP 5:
Install handlebars
First, remove the rubber sleeve from the bottom of the handlebar stem. Insert
the bottom of the stem into the rudder shaft about 6” inches. Angle the stem
to the front of the bike and tighten the bolt on the top of the stem with the six-
millimeter hex wrench provided
(A) .
Slide the handlebars into position through the eye hole at the top of the stem.
Center the handlebar and angle at your preferred position tighten the bolt
on the stem that is placed under the eye hole with the six- millimeter hex
wrench
(B) . You can adjust the height and angle of the handlebars after fully
assembled.
Place the hand grips over the handlebar ends by pushing firmly and slowly
twisting until all the way on
(C) .
STEP 6:
Attach the center console
Facing the front of the bike assembly, slide the slot in the center of the
console over the Rudder tube on the front of the Hydrobike
®
(A) . The top of
the console should be flush with the bike’s crossbar (B) .
To secure the console to the bike frame, you will use two bolts and two
wing nuts
(C) . Open the hatch and find holes in the center slot of the
console for each bolt. Press the bolt with a rubber washer through the
center slot and secure with a wing nut.