Hydro-Force Power X Pro Spot MA51, Руководство по эксплуатации, Страница: 10 / 35

10
Section
2
Troubleshooting –
Power X Pro Spot Extractor
Problem Cause Solution
Machine not Building circuit breaker tripped. Reset breaker or move cord to other outlet
turning on - Faulty power cord Replace cord
No power Faulty switches or internal wiring Check wiring & test switches - Repair as needed *
Solution Building circuit breaker tripped. Reset breaker or move cord to other outlet.
Pump Faulty power cord Replace cord
not running Faulty switches or internal wiring Check wiring & test switches - Repair as needed *
Pump faulty Replace Pump (AP30)
Low Solution Jet too large for pressure desired Check jet size & flow rates use smaller jets
Pressure
and/or
Jet worn allowing too much flow Replace jet
Pulsation Solution inlet filter plugged Clean or replace filter
Hose from solution tank restricted Repair or replace hose
Heater Restricted with scale
(MA51H Only)
De-scale or replace the heater
Pressure Relief valve stuck open
(MA51H Only)
Replace the pressure relief valve
Pump intake hose or fittings
leaking
Repair or replace hose. Tighten clamps or replace fittings
Solution tank empty Add water to tank - Check & repair auto fill assembly
Pump faulty Repair or replace pump (AP30)
Tool valve faulty Repair or replace valve
Quick connects or hoses
restricted
Clean out or replace quick connects and/or hoses
Can't connect Pressure in lines Turn off pump - Release pressure
solution hose Quick connects faulty Replace quick connects (AH101B, AH102B)
to machine Wrong style/size quick connects Replace quick connects to match connects on machine
Heater not Faulty switches or internal wiring Check wiring & test switches - Repair as needed *
Heating
(MA51H Only)
Temperature Switch tripped Reset manual reset temperature switch.
Faulty temperature switches Replace temperature switches on heater
Faulty Heater Replace heater
Flow too high for proper heating Use smaller jet or slow use of water
Water Starting out too cold Heat water before filling tank – Maximum 120˚F
* To reduce the risk of fire electrical shock or injury repairs to wiring should only be performed by
experienced service technicians.
If you are not experienced in checking electrical wiring contact your nearest authorized service
center to perform tests and repairs to wiring and switches.
Troubleshooting