Hydro-Force MA72, Руководство пользователя

Страница: 12 / 20

9
MAINTENANCE:
Proper maintenance is required to keep the Spot Extractor operating properly,
prevent downtime and to extend the life of your equipment.
This machine is an electrical appliance.
Care must be taken to reduce the risk of electrical shock. Disconnect electrical power before
performing any service or maintenance inside machine base or before testing or repairing
switches or power cords. Failure to do so may result in severe personal injury or death.
OPERATION INTERVAL PROCEDURE
CLEAN VACUUM FILTER
Buildup of debris in the filter
degrades performance as it reduces
the air flow and suction.
Daily
1. Remove Recovery Tank Lid – Twist CCW.
2. Pull Filter up & away from stand pipe.
3. Pull fibers and lint off and rinse with clean water.
4. Push the lower half of filter back onto the stand pipe.
5. Replace the recovery tank lid.
RINSE RECOVERY TANK
Clean out the tank on a regular
basis to extend the life of vacuum &
recovery components as well as
keep the tank smelling better.
Daily
1. Remove the recovery tank lid.
2. Use a hose to rinse the dirt and debris out of the recovery tank.
3. Spray the tank with a deodorizer or disinfectant.
4. Replace the recovery tank lid.
5. Dispose of the dirty water and debris.
FLUSH SOLUTION TANK
AND PUMP
Daily
(If cleaning with
anything except
clean water only)
1. Add one gallon of clean water into the solution tank.
2. Slosh the water around in the tank to clean tank.
3. Pour water out and dispose of the dirty water.
4. Pour another gallon of clean water into the tank.
5. With cord plugged in, connect the solution hose& tool to the
solution outlet quick connect.
6. Direct the tool spray into a bucket or sink and turn the solution
pump ON.
7. Spray the tool into the bucket or sink until most of the water
has been pumped out of the solution tank.
8. Turn the pump OFF and disconnect the solution hose and tool.
9. Drain the remaining water out of the solution tank and dispose
of the dirty water.
CLEAN PUMP-INLET FILTER
A restricted Pump Inlet Filter can
prevent the solution pump from
providing adequate pressure for
cleaning.
Weekly
(As needed)
1. Remove the filter screen from inside the solution tank and
clean as needed.
2. Do not operate the machine without the pump inlet filter in
place.
3. Replace filter, hose & barb as needed.
STORAGE PREP – FREEZE
PROTECTION
Freezing can cause serious
damage to the pump, pump-
out, auto-fill float valve, and
any other component
containing water.
As needed
1. In a separate container mix 1 pint of water with 1 pint of
automotive radiator anti-freeze. (Ethylene glycol type).
2. Mix well and pour into the solution tank.
3. Connect the solution hose to the solution outlet female quick
connect and hold the tool over a bucket.
4. Turn the solution pump switch to the ON position. Spray the
tool into the bucket until you see the antifreeze solution
coming out of the jet into the bucket.
5. Turn the solution pump off.
6. Drain the remaining anti-freeze solution from the solution tank
and the machine is ready for storage.
To Return to Service:
1. Repeat steps above using CLEAN WATER ONLY until anti-
freeze has been cleaned from the unit.