HYDRA-PULL HP 500, Руководство по эксплуатации и запасным частям

Страница: 28 / 77

LUBRICATION & MAINTENANCE
28
Operation Manual
SERVICE INTERVALS
Lubricate driveline every 8 hrs

Lubricate top beater bearings every 40 hrs

Check gear case oil level every 8 hrs

Check tires every 8 hrs

Check axle hub oil every 8 hrs

Grease apron chain drive bearings
& sprockets every 40 hrs
EVERY 50 HOURS

Adjust apron chain

Tighten wheel hardware

Lubricate walking beam pivots
EVERY 250 HOURS

Lubricate endgate pivots
SERVICE AS REQUIRED

Adjust apron chain tension

Slip the clutch
GEARBOX

Change lubricant every 6,000 loads
In addition to the above referenced
information, you are working with a central
lube CV design on the primary that contains a
special lubrication provision that needs to be
well defined for the user so that extended life
on the CV can be achieved.
The key point is that each CV has one zerk in
a bearing cap and it is this zerk that is most
important since it feeds the inboard cross kit
as well as the the ball and socket of the
CV. The user needs to understand that the
zerk in the cap should receive
15-20 pumps
of grease each day while the other zerks in
the joint
CV housing and telescoping members can
operate with 5-6 pumps or until the seals
purge. The plastic zerks feeding the
shielding should also receive 3-4 pumps daily
if shields are being restrained.
Primary Driveline (to Tractor) Lubricate
fittings D1 through D6 every eight hours of
operation.
Secondary Driveline (under spreader)
Lubricate as above including overrunning
clutch.
NOTE:
Lubrication step D5 is only necessary when driveline does not have grease fitting. Separate front and
rear halves of driveline and brush with grease.