Hydor HXP45041, Инструкция по установке и обслуживанию

Страница: 2 / 8

1.6 The fan is designed for use in an ambient temperature of up to 70°C (fixed
speed), 55°C (speed controlled) and up to 95% relative humidity. The fan is
not suitable for corrosive or explosive atmospheres.
1.7 The installer should provide easy access to the fan to facilitate future
maintenance.
1.8 The installer should ensure the fan is adequately supported.
1.9 This product is not intended for use by young children or infirm persons
unless they have been adequately supervised by a responsible person to
ensure that they can use the product safely. Young children should be
supervised to ensure that they do not play with the appliance.
WARNING The fan must be isolated from the power supply during
installation and maintenance. The fan must be earthed in accordance
with the local regulations.
2. Installation
2.1 The HXP range of fans is normally supplied assembled. The single phase
units are supplied with the Capacitor loose.
2.2 Upon receipt, the fan equipment should be visually inspected to check for
any damage. Ensure that the impeller is free to rotate.
2.3 If there are any queries concerning the fan equipment, Hydor should be
contacted prior to the installation.
2.4 The fan must be securely mounted in the desired position to suit the
application. The fan can be mounted at any angle.
2.5 Check the details on the motor rating plate to ensure that the correct
power supply (voltage, frequency and phase) is available. An incorrect
power supply will lead to permanent damage to the fan motor.
2.6 Refer to the appropriate wiring diagram. Ensure that all earth connections
are made.
2.7 Means for electrical disconnection must be incorporated in the wiring
installation in accordance with the relevant wiring and electrical
regulations.
2.8 Precaution must be taken to locate the exhaust discharge terminal so as to
avoid the backflow of gases into the room from the open flue of gas or
other fuel burning appliances.
2.9 If the fan is being used through a speed regulation device, either
electrically or electronically. Please refer to the relevant control device
instructions.
3. Start-up
3.1 Before power is supplied to the unit, check that the wiring is correct as per
the fan connection diagram.