Replacing the Logo! of the TDE module
FAM 5
en-US
Page 7 / 12
MOWA LogoTDE 4359963 en 2018-05-23.docx
2018-05-08
Installing the Logo! of the TDE module
In order to install the Logo! of the TDE module, proceed as follows:
1.
Prepare the Logo! of the TDE
module for installation according
to Chapter "Preparing the Logo!
of the TDE module for
assembly", page 6.
2.
Insert the Logo! of the TDE
module from the front through
the cut-out section in the door.
Ensure that it is installed
with the correct orientation
(top/bottom).
All ports/sockets are located at
the bottom.
3.
Pre-mount the set screws
provided in the holding brackets.
The tips of the set screws must
point toward the wide ends of
the holding brackets.
4.
Hook the holding brackets into
the corresponding recesses in
the unit as follows and fix the
unit in place by tightening the
set screws until the front of the
Logo! of the TDE module is flush
with the surface of the switch
cabinet at the fastening points.
Note the maximum
torque of 0.1 Nm.
