Hyd-Mech S-23, Руководство по эксплуатации и техническому обслуживанию

Страница: 27 / 71

Pg 16
S23 2001d
TROUBLE SHOOTING GUIDE
PROBLEM
1.
Cutting out of square vertically.
2. Cutting out of square horizontally.
3. Head cylinder creeps:
A)
in hold
B) in feed position
4. Blade tracking incorrect.
5. Blade stalls in cut.
6. Blade vibrating excessively.
7. Excessive blade breakage
8. No coolant flow.
9.
Blade will not start.
10. Machine stops before cut is completed or
runs on after cut is completed.
11. Head will not descend.
12. No hydraulic functions.
PROBLEM CAUSE
- Carbide guide adjustment incorrect (adjust).
- Feed rate excessive (reduce).
- Blade worn (replace).
- Guide arms too far apart.
- Blade Pitch Incorrect .
- Angle not set correctly(adjust).
- Stock not square in vise. (reset material)
- Angle pointer out of adjustment.
- Stock is not secure in the vise. (reset vise)
- Cylinder seals defective (replace).
- Head valve defective (replace).
- Hydraulic hose leaking.
- Loosen jam nut and adjust pointer with feed rate at zero.
- Improper tension (adjust).
- Tracking needs adjustment.
- Wheel is worn or in poor condition.
- More tension needed.
- Excessive feed rate (reduce).
- Blade pitch incorrect.
- Carbide guides overtightened.
- Blade speed too fast.
- More blade tension needed.
- Guide arms too far apart.
- Feed rate too slow (increase).
- Carbide guides worn or loose (adjust or replace).
NOTE: New blades tend to vibrate until they are “broken in”.
- Excessive blade tension (reduce).
- Excessive feed rate (reduce).
- Top guide(s) damaged (replace).
- No coolant (add).
- Check coolant ports for blockage.
- Line blockage (blow out lineswith compressed air).
- Coolant pump inoperable (replace).
- Coolant pump has lost its prime, loosen screws, sink pump in
coolant. When coolant starts flowing, tighten screws.
- Lift head off limit switch.
- Control fuse blown.
- Push reset button.
- If equipped, check safety interlock switches.
- Adjust head down limit switch bolt.
- Feed Rate Valve is fully closed - pointer is set on "0" or close to "0".
- Pointer is not adjusted. Loosen jam nut, turn knob fully closed,
tighten jam nut with pointer at "0".
- Check for physical interference preventing the ference preventing the
head from falling.
- Check that pressure is minimum 400 psi at gauge. If not, contact
service rep.