Timer operation (RAD20TY)
1.
To use the 24hr timer you should
select the operating mode by sliding
the switch in the centre of the timer
disk as follows:
I = On at all times
= Timed operation
0 = Off at all times
(In all modes the times will continue to keep
time whilst connected to the mains power supply).
2.
To create your own schedule you should
move the slider to the position.
3.
To set the time on the timer simply turn the outer timer disc until the arrow on
the centre timer disc points to the current time (24hr format).
4.
The timer has a total of 24hrs marked on the outer disc and these are broken
down further by four individual segments that represent 15min intervals within
that hour. Push the desired segments out, away from the centre timer disc to
confirm you would like the heater to be on at the corresponding time. Repeat
this for each 15min interval the heater is required to operate.
5.
To change the time to be off, push the segments in towards the centre timer
disc at the required intervals.
4. Maintenance
•
Always isolate the appliance from the power supply before commencing
any maintenance and ensure the unit has completely cooled.
•
Never use abrasive chemicals or materials to clean the unit.
•
Clean the exterior of the unit using a soft, dry cloth.
5
High
Low
A
B
C
I
II
0
III
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
W
H
D inc. feet
D
High
Low
A
B
C
I
II
0
III
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
W
H
D inc. feet
D
High
Low
A
B
C
I
II
0
III
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
W
H
D inc. feet
D
Riviera_Layout 1 31/05/2015 19:13 Page 5
