Hyco HF05LM, Инструкция по эксплуатации товара

Страница: 10 / 12

6. Trouble Shooting
Fault Explanation Solution
The element indicator No electrical supply Check electrical supply
Thermostat set point reached Turn up thermostat
Too little/no water Water pressure too low Check whether other cold
water taps have the same
problem
Water flow too low Open the stop-cock
No water Turn off the power supply
and refer to ‘Heater not working’
Signs of leaking Heater is leaking Notify the place of purchase
Water connections loose Tighten/ re seal connections
Tap drips Water expansion Nothing, this is normal for
vented water heaters
Bubbling noise from Too much calcification Arrange for the heater to be
the tank de-scaled.
Heater not working If the heater no longer operates, check whether the fuse or the
circuit-breaker has tripped. The hot water reservoir is equipped
with a maximum tempera- ture switch to ensure your safety.
The heater will automatically switch off if excessive heating
takes place. When this happens, isolate the power supply to
the appliance for a few minutes by removing and allow the
appliance to cool. The appliance can be reconnected to the
mains power supply again after approximately 20 minutes.
does not light up
10
HF05LM _Layout 1 18/05/2015 10:54 Page 10