background image

2

Operating instructions

for the user and for the installer

Description

The non-pressure HF05L and HF10L water 
heater keeps 5 or 10 litres of hot water avail-
able for use at any preselected temperature. 
Fig. 2 shows the time that it will take to reheat 
the water should the entire volume be used 
up.

 

• The water heater must not be 
pressurized. Never block the fitting 

outlet and do not use a Perlator or hose 
with jet controller. 

 

• If the temperature is set higher than 
45 °C, very hot water can flow immedi-
ately! 

 

• Keep children and the disabled (physi-
cal/mental) away from this unit unless they 
are supervised by a person responsible for 
their safety or have been given instructions 
on how to use it. 

 

• Ensure that children do not adjust the 
temperature (to a high temperature) on 
the unit when playing -  

Risk of scalding! 

 

• We recommend the use of the tempera-
ture restrictor set by the engineer, unless 
absolutely necessary otherwise. 

 

• To avoid risk of accidental resetting of the 
protective temperature restrictor in the 
event of a fault, the unit must not be con-
nected via a timer switch.

If you experience kettling noises or a reduced 
water flow it is likely that the unit needs 
descaling.

While the system is heating up, water will drip 
from the spout.

To select the temperature 

(Fig. 4)

1

 Control knob

 

 

=  cold. This setting protects

 

your water heater against frost. 
It does not protect your taps 
and pipework.

 

E

 (60 °C) =  Recommended energy-saving 

 

setting. Minimal scale build up.

 

85 °C

  =  Maximum temperature

   

  setting.

2

 Indicator lamp. Illuminates during the heat-

ing-up process.

Fig. 3 shows the amount of warm water 
that you can obtain by mixing cold water (at 
15 °C) to the hot water in the HF05L and 
HF10L.
Example:
with the thermostat control knob set at 
65 °C, the HF05L can supply 10 Litres of
water at 40 °C, when mixed with cold water 
at 15 °C.

Fig. 2

Fig. 4

Fig. 3

40 °C

  45 l 

  40 l

  35 l 

  30 l

  25 l

  20 l

  15 l

  10 l

 

5 l 

 

0

HF10L

HF05L

 

40 °C 

55 °C  E  65 °C 

85 °C

 

40 min

 

35 min   

30 min

 

25 min

 

20 min

 

15 min

 

10 min

 

5 min

 

0

HF05L

HF10L

 

40 °C 

55 °C  E  65 °C 

85 °C

2

1

9183.01

Содержание Handyflow HF05L









Отзывы: