1.4 | STABILITY TESTING
This machine has been stability tested to standards EN280 or AS 14180. The most adverse stability test is the
stationary, lateral slope configuration for both units.
The stability test is to be done in compliance with EN280:2013, chapter 6.1.4.2.1, or AS14180 chapter 6.5.2, on an
inclination of 2.5º, with 299.5 kg (660 lb.) on the platform, located as described in the standards.
This test can be simulated on a level surface with no load on the platform, using a side pull that causes the same
overtirning moment as the loads and inclination described above.
This equivalent test can be done as shown in the figure below.
For the HB-1230CE S3.1 the test weight/pull force is 24.6 kg (54.3 lb.)
SECTION 1 | SAFETY
MAINTENANCE & TROUBLESHOOTING
HB-1230CE
SUPO-717
REV A
8
THIS PAGE WAS INTENTIONALLY LEFT BLANK
MAINTENANCE & TROUBLESHOOTING
HB-1230CE
SUPO-717
REV A
9
