OPERATING PROCEDURES
MP34.4308
05AUG09
ROOM LIFT PROCEDURE
1. If applicable, turn in the Master Power switch
for the room lift system.
WARNING:
MAKE SURE ALL PEOPLE AND
OBJECTS ARE CLEAR OF THE ROOM BEFORE RAISING
THE ROOM. MAKE SURE THERE IS ADEQUATE
CLEARANCE TO FULLY RAISE THE ROOM.
HYDRAULIC SWITCH
SIDE VIEW
NEUTRAL - STATIONARY POSITION
UP POSITION
HYDRAULIC SWITCH
3. Push and hold the "PUMP CONTROL SWITCH"
TOP VIEW
2. Move the hydraulic switch to the "UP" position.
SWITCH
CONTROL
PUMP
PUSH AND
HOLD
CONTROL
PUMP
SWITCH
PUSH AND
HOLD
P
N
D
W
O
U
N
U
D
W
O
P
NOTE: Releasing the "PUMP CONTROL SWITCH"
will halt the operation of the room.
direction of the room, contact HWH Customer Service
immediately. DO NOT force the room. DO NOT reverse
room stops moving, release the room control switch
If either side of the
reversed, DO NOT re-extend the room until the room
the room. If the direction of the room has been
of the room may be reversed, but watch for binding of
the room is fully extended. If necessary, the direction
During normal operation
Do not hold the "PUMP CONTROL SWITCH"
Hold the "PUMP CONTROL SWITCH" three or four
seconds after the room is fully extended. This assures proper
of the room, do not reverse direction of the room until
in the on position for more than ten seconds after the room
is fully extended or stops moving.
has been fully retracted.
pressurization of the cylinders.
IMPORTANT:
NOTE:
for assistance 1-800-321-3494.
4. When the room is completely raised, release the
"PUMP CONTROL SWITCH".
5. Move the hydraulic switch to the neutral position.
WARNING:
ROOM LOCKING, CLAMPING OR MANUAL RETRACTING
DEVICES ATTACHED OR ENGAGED CAN CAUSE
PERSONAL INJURY AND VEHICLE DAMAGE. IT IS THE
OPERATOR’S RESPONSIBILITY TO ENSURE THAT
ALL ROOM LOCKING, CLAMPING OR MANUAL
RETRACTING DEVICES ARE DETACHED OR
DISENGAGED BEFORE OPERATING THE ROOM.
OPERATING A ROOM WITH ANY
