OPERATING PROCEDURES
RETRACT PROCEDURES
MP35.1026
09MAY97
3. Start the vehicle engine and let air pressure build up in the
suspension.
CAUTION:
DO NOT MOVE THE VEHICLE WHILE THE
LEVELING JACKS ARE STILL IN CONTACT WITH THE GROUND
OR IN THE EXTEND POSITION. THIS VEHICLE IS EQUIPPED
WITH STRAIGHT-ACTING JACKS. MOVING THE VEHICLE
WITH THE LEVELING JACKS EXTENDED CAN CAUSE
SEVERE DAMAGE TO THE JACKS AND OR THE VEHICLE AND
CREATE A DRIVING HAZARD. DO NOT RELY SOLELY UPON
WARNING LIGHTS. IT IS THE OPERATOR’S RESPONSIBILITY TO
CAUTION:
THE STORE LEVERS SHOULD BE KEPT
IN THE "STORE" POSITION WHILE TRAVELING TO KEEP
THE JACKS IN THE STORE/TRAVEL POSITION.
CAUTION:
MAKE SURE THAT PEOPLE AND EQUIP-
MENT ARE CLEAR OF THE VEHICLE.
CHECK THAT ALL JACKS ARE FULLY RETRACTED INTO
THE STORE/TRAVEL POSITION AND THAT THE VEHICLE
JACK POSITIONS
2. Visually check that all jacks are in the STORE/TRAVEL
IS AT THE PROPER RIDE HEIGHT BEFORE MOVING THE
VEHICLE.
4. Push the rocker switch on the jack control plate to "OFF".
Turn the ignition to off or proceed to travel.
IMPORTANT: Always retract the two front jacks first.
1. Move the two front control levers to the STORE position.
Retracting the jacks in pairs (front and rear) will provide a smooth
retraction. Move the rear control levers to the STORE position.
EXTEND POSITION
STORE/TRAVEL POSITION
position. With the ignition switch in the "ON" position and the
rocker switch in the "LEVEL" position, the red "WARNING"
lights, the master "JACKS DOWN" light and the buzzer will be
off. Check that the vehicle is at the proper ride height.
