HWAM F 30, Руководство пользователя

Страница: 10 / 48

10
• Wall rosette (13). Covers disruption to wall around pipe sleeve.
• Joint (14). Sealed with packing material.
• Smoke outlets (15) of the HWAM stove.
• Smoke flue regulating damper (16).
• Soot door (17).
Connecting external supply of fresh air
The HWAM F 30/55s can be connected to a fresh air system . The fresh air system can be purchased
separately .
Fitting the loose parts (Drawing C)
Before you start using the insert, you must ensure that all loose parts are fitted correctly .
a . Smoke plate (1) . Must lie on the rear plate and on the slanting side plates . It must fall into position in
the track on the rear plate .
b . Steel smoke deflector plate (2) . Is mounted on two hooks . To mount the plate, lift it up and lead to
the right until it is hanging on the two hooks .
Adjusting the feet (Drawing D)
If required, the feet at the bottom of the plinth module may be adjusted .
1 . Remove the six screws (1), and carefully lift the rear plate (2) off the top module (make sure that the
rear plate does not fall out when the screws are loosened) .
2 . Loosen the two screws (3) and lift the top module (4) off the plinth module (5) .
3 . Set the adjustable feet (6) to the required height .
4 . Then reinstall the top module (4) including the combustion chamber on the plinth module (5), and
secure the two screws (3) again .
5 . Reattach the rear plate (2) to the stove with the six screws (1) .
Chimney
The chimney is the “engine” of the stove and it is crucial for the functioning of the woodburning stove .
The chimney draft provides a partial vacuum in the stove . This vacuum removes the smoke from the stove,
sucks air through the dampers for the so-called glass pane rinse which keeps the glass free of soot, and
sucks in air through both primary and secondary dampers for the combustion .
The chimney draft is created by the differences in temperature inside and outside the chimney . The higher
the temperature within the chimney, the greater the draft . It is crucial, therefore, that the chimney is warmed
up properly before closing the damper and limiting the combustion in the stove (a brick chimney takes
longer to warm up than a steel chimney) . On days where the weather and wind conditions create insufficient
draught inside the chimney, it is even more important to warm up the chimney as quickly as possible . The
trick is to quickly get some flames going . Split the wood into extra fine pieces, use an extra firelighter, etc .
If the stove has not been used for a longer period, it is important to check that the chimney pipe is not blocked .
It is possible to connect several devices to the same chimney . However, it is important to first check the
applicable rules .
Even a good chimney can function badly if it is not used correctly . Similarly, a bad chimney may function
well if used correctly .
Chimney sweeping
To prevent the risk of chimney fires, the chimney must be cleaned every year . The flue duct and the smoke
chamber above the baffle plate must be cleaned together with the chimney . If the chimney’s height makes
cleaning from above impossible, a cleaning hatch must be installed in the chimney .