HWAM 5530, Руководство пользователя

Страница: 7 / 12

Page 7 of 12 pages
HWAM ® SmartControl TM closes all three air dampers when the stove is in standby mode. This prevents hot air from the room to enter the
chimney (heat loss). This might on the other hand result in a very cold chimney when the stove is lit. In certain cases it is necessary to assist
the draught in the chimney by burning a couple of newspaper pages on top of the wood ready to be lit. Read more on www.hwam.com
about the function of the chimney.
Important!
The appliance must not be operated with the door left open except as directed in the instructions. The door must not stay open while lighting
up. It must always be closed when the stove is in use. Otherwise the stove’s intelligent control system does not function. The door should only be
opened when lighting up, when restoking, and when cleaning the stove. Never leave a stove before there are lasting flames in the wood after firing!
The Thermostat Function
HWAM ® SmartControl TM will in general have an environmentally friendly combustion and adapt to the desired room temperature. The thermo-
stat function is designed as a radiator valve. The user enters a desired heat level, which suits the room in which the stove is installed. When the
thermostat is set at a heat level, the control function will adapt to this temperature.
• If the room temperature is lower than the desired heat level, the control function increases the flue gas temperature in order to increase the
heat radiation from the stove.
• If the room temperature is higher than the desired heat level, the control function decreases the flue gas temperature, thereby giving the layer
of embers as long a life as possible before re-stoking. This will reduce the heat radiation from the stove and facilitate re-stoking without having
to light up the fire anew. If the room temperature drops below the desired level, the ember phase will be shortened, and the system will activate
a re-stoking alarm. The system will signal that a re-stoking is due at the flue gas temperature of 180° C, and at 100° C the system will enter
standby mode and all dampers will close.
• Should the room temperature be much lower than the desired heat level, the control function increases the flue gas temperature. If a satisfactory
increase in temperature does not occur, the control will activate a re-stoking alarm, since it expects that more wood is needed to increase the heat
level in the room.
• If the room temperature after a new re-stoking still does not reach the desired level, the water content in the firewood may be too high or the
draught in the chimney too weak. HWAM ® SmartControl TM always strives for a sufficiently high flue gas temperature to ensure an environmen-
tally friendly combustion.
Stoking
When alarm for re-stoking sounds the stove is ready for re-stoking. The alarm for re-stoking will come via the room temperature sensor. The
app IHS Smart Control
TM will also come with a notification that it is time for re-stoking if the app is opened. For more information on the app,
see separate manual.
The amount of woo that is used for re-stoking should be adjusted based on the current heat demand. In terms of combustion technique, you
should always stoke the stove with at least two pieces of wood at a time even if you only use a small amount of wood. The firewood cannot be
stacked higher than as indicated on the rear insulation plate (see illustration).
You can also choose not to restoke. After a while the stove will then automatically go into hibernation.
Important!
Never leave a stove before there are lasting flames in the wood after re-stoking!
During combustion, the outer surfaces of the stove will become hot, and due care must therefore be shown.
Firing with coal and pet coke
HWAM 5530 is not suitable for firing with coal or pet coke.
Indication for max height of stacking wood