HW Group Poseidon2 3468, Руководство пользователя

Страница: 12 / 20

Poseidon2 3468
– Manual
HW group
www.HW-group.com 12
Outputs
Output mode:
A)
Manual
Output can be controlled using the Web interface or externally using M2M protocols.
The output
cannot be used in “thermostat” mode – local condition.
B)
Local Condition
The output cannot be controlled using the Web interface, it is controlled by the local
condition. The output is read-only for all M2M protocols. Hysteresis configured in the sensor
settings applies.
The output cannot be controlled remotely.
o
On if any alarm
The output is active if at least one input or sensor is in alarm.
o On if value equal to Trigger
The output is active if the selected sensor reading is equal to
the “Target Value”.
o On if value higher than Trigger
The output is active if the selected sensor reading is greater than
the “Target Value”.
o
On if value lower than Trigger
The output is active if the selected sensor reading is less than
the “Target Value”.
o Dependent On
–
sensor / input to which the condition applies.
Choose the output mode
Manual mode:
Output controlled over the WEB
or M2M protocols
Local Condition mode:
Controls the output according to
the specified sensor