Poseidon 3268 – starting guide
Oficjalny dystrybutor:
ATEL ELECTRONICS
600 311
Temp-1Wire-Outdoor 3m
600 330
HTemp-Rack19
600 279
Humid-1Wire 3m
600 040
Poseidon T-Box
600 280
Poseidon T-Box2
600 240
PowerEgg
2) Configuring the IP address
The UDP Config executable is located in the root of the
supplied CD (Windows and Linux version), or it can be
downloaded at
www.HW-group.com
Config.
•
Click the icon to run UDP Config
automatically starts searching
devices.
•
Click the Find Devices button to start searching
for devices.
The program looks for devices on your local network. To identify a particular Poseidon unit, look at its
MAC address (printed on the label at the bottom of the unit).
click a MAC address to open a dialog window with basic device settings
Configure network parameters
•
IP address / HTTP Port (default is 80)
•
Network mask
•
Gateway IP address
•
Device name (optional)
Click the Apply Changes button to sa
Note: Contact your network administrator if you are unsure about these settings.
•
Reset to factory defaults
Toggle DIP1 several times within 5 seconds after powering up. Default settings
contains none passwords.
DIP1
•
Disable
any configuration changes
While DIP2=On any configuration change disabled.
Note: Set Dip2=Off to be able change IP address configuration
DIP2
Door Contact
600 119
Poseidon T-Box
600 040
Oficjalny dystrybutor:
www.atel.com.pl
45-231 Opole
e-mail: [email protected]
ul. Oleska 121
Temperature sensor for outdoor use, food-safe steel,
Temp & humidity sensor, installs into a RACK as a 1U device
Humidity sensor, 3m cable (1m = 600 278)
Hub to connect up to 5 sensors, 10cm cable
Hub to connect 2 sensors, 3m cable
Power detector / control - 110/230V mains voltage detector
I1..I4 of a Poseidon) and switch (connect to O1 / O2
address – UDP Config
is located in the root of the
(Windows and Linux version), or it can be
group.com
, Software -> UDP
UDP Config. The program
starts searching for connected
button to start searching
The program looks for devices on your local network. To identify a particular Poseidon unit, look at its
MAC address (printed on the label at the bottom of the unit). Double
dialog window with basic device settings.
(default is 80)
button to save the settings.
Contact your network administrator if you are unsure about these settings.
Reset to factory defaults
Toggle DIP1 several times within 5 seconds after powering up. Default settings
contains none passwords.
any configuration changes
(online demo mode)
any configuration change disabled.
Note: Set Dip2=Off to be able change IP address configuration
Box
HTemp-Rack19
600 330
Temp-1Wire 1m
600 242
HW group
tel. +48 (77) 455 60 76
fax. +48 (77) 455 80 56
safe steel, 3m cable
Temp & humidity sensor, installs into a RACK as a 1U device
mains voltage detector (connect to
O1 / O2 of a Poseidon 3268)
The program looks for devices on your local network. To identify a particular Poseidon unit, look at its
Contact your network administrator if you are unsure about these settings.
Toggle DIP1 several times within 5 seconds after powering up. Default settings
(online demo mode)
Note: Set Dip2=Off to be able change IP address configuration
m
Humid-1Wire 3m
600 279
