HUYGENS OPTICS
CS-2/3 camera strobe manual V01
4
General
About this manual
This manual is intended for persons who are responsible for the installation, use and maintenance of
the Huygens Optics CamStrobe versions CS-2 and CS-3 (hereafter referred to as CS-2/3). For safe and
proper working with the device it is required that the device is used in compliance with all the safety
and handling instructions in this manual. In addition, local accident prevention regulations and
general safety rules for the location of use must be complied with.
Installation and use should only be done by persons with a sufficient level of knowledge on these
subjects. Read the operating instructions carefully before attempting any work on or with the
device. This manual should be kept in the immediate vicinity of the product for future reference.
In case you have any questions that are not answered in this manual, please contact your local
distributer or visit the Huygens Optics website at
www.HuygensOptics.com
for contact information
Name plate
The CamStrobe versions CS-2 and CS-3 can be identified by the name plate located on the back side
of the unit. The name plate also contains the serial number of the unit. Please note the serial
number of the unit here for future reference and in the case of communication with Huygens Optics.
TYPE:
SERIAL NUMBER:
Limitation of liability
The manufacturer assumes no liability for damage and operation faults resulting from:
•
Failure to use according to these operating instructions
•
Improper installation by insufficiently-trained staff
•
Faulty electrical and mechanical connections
•
Use for other purposes than the intended purpose of this product
•
Failure to use original replacement and accessory parts
•
Any technical modifications done to this product without approval of Huygens Optics
•
Failure to perform maintenance required for this product
Particular hazards
WARNING:
This product produces high intensity light flashes in the frequency
range between 1 and 150 Hz. These flashes can induce epileptic fits, even with
people who have previously never experienced epileptic fits before. Make sure
that persons susceptible to epileptic fits are not in the vicinity when using this
product. In addition, looking directly or even indirectly into the light beam can
cause temporary loss of vision, especially in dark environments.
WARNING:
Operating the device can make fast-moving parts appear to be
standing still. This visual illusion can lead to
serious or even fatal injuries if not
recognized as such
by those observing. Please inform everyone in the vicinity
of this optical effect, to prevent them from accidently reaching into a running
machine.
