Huvema MIP 30, Руководство пользователя

Страница: 7 / 17

-6-
8. Round profile 30 < D
≤
60
MIP 30-15-11-0
Guide roll 60 MIP 30-15-11-1 2
Guide roll 55 MIP 30-15-11-2 2
Guide roll 50 MIP 30-15-11-3 2
Guide roll 45 MIP 30-15-11-4 2
Guide roll 40 MIP 30-15-11-5 2
Guide roll 35 MIP 30-15-11-6 2
Leading roll 60 MIP 30-15-11-7 1
Leading roll 55 MIP 30-15-11-8 1
Leading roll 50 MIP 30-15-11-9 1
Leading roll 45 MIP 30-15-11-10 1
Leading roll 40 MIP 30-15-11-11 1
Leading roll 35 MIP 30-15-11-12 1
Short distance piece MIP 30-8-3 3
Long distance piece MIP 30-8-4 3
3. Technical characteristics
Diameter of roller shaft .............................. mm........................Ø 30
Diameter of leading roller .......................... mm...............Ø 118-148
Speed of leading roller .............................. min
-1
......................... 20
Motor ........................................................ 400V, 0.75 kW, 1500 min
-1
Length....................................................... mm..........................620
Width ........................................................ mm..........................480
Height ....................................................... mm........................1360
Weight ...................................................... kg ............................170
Subject to change.
4. Operation
After setting the material to be bend between rollers, drive the leading roller by hand in the bending direction.
The desired profile bending is obtained by turning the upright driving shaft of the slide way gradually as well as
the position of the main roller shaft. The guiding rollers are driven by the bending mechanism activated by the
electric motor. It allows repeated travels in both directions. Starting of the electric motor in both directions is
possible by using the double pedal.
5. Labour protection rules
- For your own safety, disconnect the machine from the power source before maintaining or repairing it.
- It is forbidden to intervene to the gears during operation. They are protected by guards.
- Clothing and the tools you use for interventions have to be proper for the work you make.
- Check the fastening of the bending rollers on the shafts before starting the machine.
- Do not use pinched or cracked bending rollers.
6. Maintenance
Clean, grease and make the necessary adjustments before each operation. Check the temperature of the
bearings (touching them by hand) during operation. The temperature must not exceed 50 ˚ .