Huvema HU 50 G-4 TOPLINE, Инструкция по эксплуатации

Страница: 10 / 24

14. M
aintaining
T
hat’s easier to keep machine in good condition or best performance by means of maintaining it at any time
than remedy it after it is out of order.
1. Daily Maintenance (by operator)
- Fill the lubricant before starting machine daily.
- If the temperature of spindle caused over-heating or strange noise, stop machine immediately to
cheek it for keeping accurate performance.
- Keep work area clean; release vise, cutter, work-piece from table; switch off power source; take chip
or dust away from machine and follow instructions lubrication or coating rust proof oil before leaving.
2. Weekly Maintenance
- Clean and coat the cross leading screw with oil.
- Check to see if sliding surface and turning parts lack of lubricant. If the lubricant is insufficant, fill it.
3. Monthly Maintenance
- Adjust the accurate gap of slide both on cross and longitudinal feed.
- Lubricate bearing, worm, and worm shaft to avoid wear.
4. Yearly Maintenance
- Adjust table to horizontal position for maintenance of accuracy.
- Check electric cord, plugs, switches at least once a year to avoid loosening or wearing.
15. C
leaning
&
lubricating
16.1 C
leaning
1. Your machine has been coated with a heavy grease to protect it in shipping. This coating should be
completely removed before operating the machine. Commercial degreaser, kerosene or similar solvent may
be used to remove the grease from the machine, but avoid getting solvent on belts or other rubber parts.
2. After cleaning, coat all possible rusted surface with a light lubricant. Lubricate all points with a
medium consistency machine oil.
16.2 L
ubrication
All ball bearings in your mill/drill are sealed for life, requiring no lubrication. Points
requiring lubrication are:
1. Internal spline drive assembly. Keep this area well lubricated with a good grade non-hardening grease,
such as Fiske Company “Lubricate”. Insert grease in the hole at the top of spindle pulley spline driver.
Lube twice yearly.
2. A light film of oil applied to the quill and column will reduce wear. prevent rust, and assure ease of operation.
3. ) Quill return spring should receive oil (SAE 20) once yearly. Remove cover plate and apply oil with
squirt can or small brush.
4. IMPORTANT: The gear box should be oiled with a lubricant such as SAE 68 oil in level. Change oil
every one year.
5. Apply Lubricate to quill pinion every 90 days.
Note . Use extreme care when performing this operation and keep hands clear of pinch points. When
using paraffin bar, do this only by turning the sheaves by hand. Do not apply with motor running.
16.3 C
hanging the gear box oil
Tilt the hard stock over as shown in Fig.1. Open the oil drain plug to allow the oil to drain from the opening
completely. Then lock the oil drain plug and turn the head to be upright position. Remove the oil filler plug fill
the oil to the gear box until the oil lever reach the middle of oil fluid lever indicator. Then lock the plug.
10