HuTools HT02 Скачать руководство пользователя страница 4

3 / 6

Information & Safety Warnings

Protect your User Codes and Master Code.

Restrict access to your lock’s interior assembly and routinely check your settings to ensure they have not been altered 
without your knowledge.

This lockset is designed to provide the highest standard of product quality and performance. Care should be taken to ensure 
a long-lasting finish. When cleaning is required use a soft, damp cloth. Using lacquer thinner, caustic soaps, abrasive 
cleaners or polishes could damage the coating and result in tarnishing.

IMPORTANT: Do not load batteries until lock is completely installed.

1

2

3

4

5

6

7

8

9

A.

1

2

3

4

5

6

7

8

9

B.

2

2

2

2

2

2

2

2

2

C.

3

8

6

5

D. If

Then

and

Forward number sequence

Backward number sequence

Repeat number sequence

3

8

1

9

6

5

1

9

3

8

6

5

Contain existing code sequence 

1. Master Code( 4 to 10 digits) :  The default Master Code is 12345678. It is required that you change it to a code of your 
own before programming.

2. User Code(4 to 10 digits) : A total of 20 User Codes (and one temporary one-time User Code) may be programmed.   

3. Both master and user pin codes don not support the following combination of numbers.

 

Programming Instructions

How To Use

UNLOCK the door with fingerprint ID

UNLOCK the door from outside

LOCK the door from outside

LOCK the door from inside

Master/ User
code

Touch and hold the 
Sensor with your finger 
to unlock the lock.

Auto Re-lock Mode

In Auto re-lock mode, the bolt will 
extend out automatically in 30 seconds 
after unlocking.

Manual Mode

Press any key on keypad for 2 seconds.

Auto Re-lock Mode

In Auto re-lock mode, the device 
will be locked automatically. 

UNLOCK the door from inside

Rotate the thumb turn to 
Unlock position.

Manual Mode

Rotate the thumb turn to Lock position.

Содержание HT02








Отзывы: