HuTools HT02 Скачать руководство пользователя страница 3

2 / 6

3

Install exterior assembly

A

IMPORTANT: Before installation, make sure the latch is fully retracted (in the unlocked position) . 

Route the cable below the latch

B

Secure the mounting plate with the supplied screws. 

D

J

Keep Parallel to door edge.

unlocked

Insert the torque blade 
through the slot in the latch.

Send the cable through the bottom horizontal slot in the mounting plate.

C

E

unlocked

4

Install interior assembly

Connect the cable and ensure tight cable connection.

B

Rotate the turnpiece in vertical position and the torque 
blade in horizontal position, make sure the latch is 
still fully retracted (in the unlocked position). 

C

Test operation using backup key and thumbpiece 
for smooth rotation.If turnpiece doesn’t rotate, 
repeat step 4C, making sure the turnpiece in vertical 
position, and touque blade in horizontal position.

D

IMPORTANT: Do not load batteries until lock is completely installed.

Remove the battery cover.
Locate the slot at the bottom and use your fingernail or a 
flat head screwdriver to pry the cover up and pull it off. 

A

Secure the interior assembly 
with the supplied screws.

E

K

Horizontal

G

F

5

Detect left/ right hand door installation

While the door is OPEN and UNLOCK, load 3 AA batteries 
into the interior assembly. For best results, use new, 
non-rechargeable Alkaline batteries only.

Press and hold the Reset button on the interior assembly 
using a pen or a paper clip. 

Reset the lock to teach the lock the orientation of the door.

A

Press and hold the Reset button on the interior assembly 
using a pen or a paper clip. 

B

Load the last battery and keep holding the reset button 
for 3 seconds, until you hear the sound of “beep”. The 
latch bolt will extend to learn the orientation of the door.

C

IMPORTANT: This step is required and crucial for the lock to operate properly. 

unlocked

Содержание HT02








Отзывы: