6
OPERATION USE
WEAR EYE PROTECTION
1.
Be sure the arbor is fully secured to the gun head shaft.
2.
Before operating machine, keep hands and fingers clear of pinch points.
3.
Select the segment set according to the color code expanding chart on the housing.
4.
Select the correct arbor tip that matches the segment set according to the color chart
on the housing. The small tip is only used with the small red segment set.
5.
Install the correct tip on the arbor. Tighten the tip to the arbor with a wrench and light
pressure.
6.
Install the selected segment set over the arbor by pressing the center of the opening
over the arbor tip and arbor.
7.
Lubricate the arbor and face of the adjustable collar of the gun head where the base
of the segment set rides across it.
8.
Select the desired expanding size by rotating the adjustable collar of the gun head
until the desired number setting is displayed in the indicator hole of the sight.
9.
Holding the gun head firmly by the grip handle, place the segment set into the tube.
Depress the foot pedal of the pump until the tube expands slightly. This operation
helps remove any burrs on the tube end.
10.
Release the foot pedal allowing the segment set to relax. Slightly rotate the segment
set and depress the foot pedal. Expand the tube halfway to the desired diameter.
11.
Release the foot pedal and slightly rotate the segment set to expand the tube area
that was not expanded in the last operation. Continue until the desired diameter is
reached. The pump tone will change when maximum expansion is reached.
12.
Release the foot pedal, slightly rotate the segment set, depress the foot pedal and
expand to round out the expansion.