cm to 1.9 cm) below the deck. With the unit sitting on a flat
level surface, the front wheel position can be adjusted up or
down as needed from 3/4” to 1-3/4” (1.9 cm to 9.5 cm)
below the blade surface. Move the front wheels up or down,
in 1/2” (1.3 cm) increments, using the different axle mount
holes in the wheel mount bracket. Fig. 5-25
When adjusting the rear anti-scalp wheels, the wheel
should be in the lower axle mount hole when the front anti-
scalp wheels are in the lower or middle axle mount holes.
When the front wheels are in the upper axle mount hole, the
rear wheels should be in the upper axle mount hole as well.
NOTE:
When the anti-scalp wheels are installed, the
minimum cutting height is 1” (2.5 cm) with the anti-scalp
wheels set at 3/4”.
Figure 5-25
Adjusting
holes
Anti-scalp
wheel