SGN141S-1 R290 Self-Contained Low Height Open Refrigerated Display Cabinet
Manual
Ju
ly
2021 Final Rev: 30A01
15
Regular Inspection
To ensure reliability of the cabinet and leak tightness of the refrigerant circuit, it is advisable that
trained personnel carry out periodic maintenance.
Case should be cleaned and inspected by store staff on a daily basis.
•
If an alarm system is not part of the refrigeration installation, the temperature of each case
should be checked on a daily basis.
•
The case discharge air temperature should be within the following ranges of -4°C ~ +1°C,
unless on defrost.
o
If it is consistently outside the above temperature ranges, contact your service
provider.
•
Visually check the case for damage or spills and take appropriate remedial action.
Cleaning
•
Do not use hot water on cold glass surfaces as the glass may shatter and cause serious
injury.
•
When flushing the waste drain, do not use high-pressure water hoses and be careful not
to introduce water faster than the waste outlet/drain can drain it. This SGN141S-1 cabinet
does not have a floor drain. Do not bucket more than 1 litres into the case during cleaning.
CAUTION: -
Do not climb in or on the cabinet as
this may result in personal injury and/or case
damage.
1. Remove stock from the case and store below +5°C.
2. Turn off power to the case (electrical).
3. Remove all price tickets and any foreign materials from the case. Particularly the air return
grille / base liner / and defrost tray.
4. Remove shelves and clean with a sponge, warm water and mild detergent, then rinse and
wipe dry.
5. Remove the base trays, wash with mild soapy water and rinse.
6. Carefully flush the waste drain with a small amount of water (less than 2 litres) and allow
the base to drain. NOTE: - monitor the condensate tray levels in the lower section of the
cabinet.
7. Clean the drain area with a soft brush and warm water.
8. Clean the inside of the case (paying particular attention to the perforations in the rear
panels) with a clean soft cloth, warm water and mild detergent.
9. Clean glass or mirrored surfaces with a clean soft cloth and mild glass cleaner.
10. Wipe LED lamps with a dry cloth (ensure lights are powered off).
