C2-XGEP
Technical Data Sheet
HUSSMANN CORPORATION, Bridgeton, MO 63044-2483 U.S.A.
8 of 8
Impact
C2-XGEP
Dairy / Delicatessen
Precut & Packaged Produce
Foil-covered
Anti-sweat
Heater
Canopy
Canopy
Anti-Sweat Heater Wires
with Purple Markers
Electrical
Wireway
Ballast
Light Tray
Hinge
Remove Screws
Light Tray
Light Tray
The ballast for the canopy and shelf lamps is located
behind the light tray on the left-hand end (when
facing case) of the merchandiser.
To access the ballast:
1. Remove screws from the front-lip of light tray
flange covering the bottom edge of the canopy.
Also remove screws located near the middle-rear
of light tray.
2. Swing front of light channel down on it’s rear
hinge.
3. Service or replace ballasts as required.
4. Reassemble items as they were originally
installed. Make sure that wires are not pinched
by re-installed light tray.
NOTE
: Rail lamp ballast is located behind the
lower front panel.
CANOPY ANTI-SWEAT HEATER
The canopy anti-sweat heater location is shown
below. Connections are in the Electrical wireway.
