Hussmann HGM-1 BS, Руководство по установке и эксплуатации

Страница: 64 / 70

99-18258-I002_A 5/18/2010
11
CONNECTING THE WIRE PLUG ASSEMBLY TO THE
LED FIXTURE WIRES
1. Connect wires from the fixture to the black and red wires from the 2-conductor
harness using Wago Wall-NUT connector part number 773-162 or other approved
connectors.
NOTE: Half power end fixtures need to be connected together.
Refer to
„WIRING DIAGRAMS and ORIENTATION” on page 14.
2. Tuck the wire connectors underneath the wire cover before snapping it to the end cap.
3. Make sure the wire cover is locked into the end cap.
4. Remove the protective film from the lens.
5. Seal off the cutouts in the Mullions using insulating material.
6.
Go to „MOUNTING THE LED POWER SUPPLIES” on page 12.
Connecting Wires at the Top of the Frame
1. Connect wires from the fixture to the black and red wires from the 2-conductor
harness ( Refer to „RETROFIT PARTS LIST” on page 3) using Wago Wall-NUT
connector part number 773-162 or other approved connectors.
NOTE: Half power end fixtures need to be connected together.
Refer to
„WIRING DIAGRAMS and ORIENTATION” on page 14.
2. Tuck the wire connectors underneath the wire cover before snapping it to the end cap.
3. Make sure the wire cover is locked into the end cap.
4. Remove the protective film from the lens.
5. Seal off the cutouts in the Mullions using insulating material.
6.
Go to „MOUNTING THE LED POWER SUPPLIES” on page 12.
Connecting Wires at the Bottom of the Frame