Hussmann ENTYCE TY3, Руководство по установке и эксплуатации

Страница: 10 / 57

10
Do Not Install the Vented Panels of the
self-contained model against a wall or
other storage fi xture.
Located in the lower front and rear of the self-contained
models are vented panels. These panels allow air circulation
to the condensing unit. Blocking or restricting air circulation
through these panels can cause poor performance and
damage the refrigeration system.
Exterior Loading
These models have not been structurally designed to support
excessive external loading.
Do not walk on their tops;
This could cause serious personal injury and damage to
the fi xture.
Leveling
A LEVEL CASE IS NECESSARY TO INSURE PROPER
OPERATION AND WATER DRAINAGE.
Note: To avoid removing concrete fl ooring, begin lineup
leveling from the highest point of the store fl oor.
Store Conditions
Uncrating the Stand
Place the fixture as close to its permanent position as
possible. Remove the top of the crate. Detach the walls from
each other and remove from the skid. Unbolt the case from
the skid. The fi xture can now be lifted off the crate skid.
Lift
only at base of stand!
Installation
Condensate Pan Setup
There is one condensate evaporator pan on this unit. The drain pipe from the case feed into the condensate pan, once
water levels are high enough in the condensate pan the fl oat switch level is triggered which will then trigger the heater to
raise temperature therefore evaporating the water into the case airstream.