2
REMOVE ITEMS FROM
PARENT CASES
/
APPLY
GASKETS
Remove shelves (if installed),
display racks, honeycomb, pans,
front shelf supports and front air
grilles from the right end as shown
in
Figure 2A.
Remove the lower back panel first
by lifting up from its bottom edge
and out. Do not use sharp tools.
Lift the upper back panel up and
out. Remove factory installed nut
retainers along vertical frame of
parent cases, (if installed).
Apply
1 in. Gasket (Item 1)
around
perimeter of parent cases as shown
in
Figure 2B.
Check that there are
no gaps between gasket and case.
Apply
1
5
/
8
in. Gasket (Item 2)
so
that one edge is on the metal case
frame and the parallel edge laps the
1 inch gasket. Check that there are
no gaps between case and gaskets.
P/N 0508902_A
3
HUSSMANN CORPORATION • BRIDGETON, MO 63044-2483 U.S.A. • WWW.HUSSMANN.COM
D5XEE & D5XELE to D5X Lineup
Joining Instructions
First Gasket
1 in. Gasket
(24 mm)
Second Gasket
1
5
/
8
in. Gasket
(41 mm)
IMPORTANT
• Do not stretch gasket,
especially around corners.
• Do not butt gaskets;
always overlap them as shown.
• Remove paper backing
after gasket has been applied.
•
Perimeter gasket required by NSF.
FIGURE 2A
Remove Items from Parent Cases / Apply Gaskets
FIGURE 2B