10
Installation (Cont'd)
•Vertical Adjustment
1. Remove
top glass
and panel
enclosing
mini-top
hardware.
2. Lift open
glass panel(s)
and relieve
tension on
hinge.
3. Loosen hex screw
(1/4” allen).
4. Add or remove
shims as needed.
(see note on shims
below)
5. Close glass panel(s)
and check alignment
Retighten hex screw
and reinstall removed
NOTE: Standard shims thickness is 1/16”
Back of
Case
Joint Trim
After cases have been leveled and joined, and refrigeration,
electrical, and waste piping work completed, install the
splashguards and joint trim where necessary. Fasten the
splash guards along the top edge, or center, with 3/8"
long sheet metal screws. If needed, use silicone sparingly
to caulk the joint trim and exterior body panels with an
appropriate colored silicone to ensure that a cleanable
and professional appearance is achieved. Use
a fi nger in
a clean rag, as you go, to create smooth and neat joints,
while the silicone is still fl uid.
DO NOT SEAL JOINT TRIM OR SPLASHGUARDS TO
THE FLOOR!
Содержание CR3HV-ND
Страница 23: ...23 Wiring Diagrams Cont d 0 1 2 1 2 1 2 3 3 3 3 3 3 1 2 3 3 3 4 4 4 4 4 4...
Страница 29: ...29 13 Spec Sheets...